Cutterbar shelf v1.1.0.0 LS22

Cutterbar shelf v1.1.0.0 LS22

Here is a pack of cutter bar shelves!

V1.1.0.0
What was changed:
clip distance has been adjusted
Textures have been swapped and adjusted
Parts of the 3d model were redone and new masks were created
BeaconLights have now been added
Added visual icon markers

A new universal bearing has been added, with which it is now possible to decide for yourself which cutting unit is on which compartment. All standard cutters are registered with ModSchneidwerke that have the same xml/name, it should also work.

Another warehouse has been added and the Ropa cutter bars can now also be stored. With the ropa camp, it is also the case that you can decide where which goes.

In these storage facilities, it is possible to store cutters and grinders by the manufacturer. There are 7 warehouses available, each of them has 5 compartments and can be controlled via a control panel.

This header storage pack contains 7 different storage slots for cutters and shredders.
Header bearing CapelloPrice: 45000€
Maintenance: 15€ per day
Function: using the 5 shelves, it is possible to store the cutting units. To the left and right of the shelf is the control panel from which you can operate the shelf.
There are different trigger points in front of the control panel, e.g. allowing the opening of the panel as well as the associated triggers for the extension and retraction of the 5 shelf compartments.